Zetor FORTERRA HSX 130 - Front PTO Shaft; Activation of the Front PTO Shaft - Common Working Mode

Front PTO shaft
Activation of the front PTO shaft -
If the operator leaves the driver's seat with the front PTO switched on with the tractor
stationary, an acoustic signal sounds and the front PTO switches off automatically after five
seconds. The front PTO can be switched on again, when the operator sits in the driver's seat and
p
resses the button on the ri
g
ht cab column.
If the operator leaves the driver's seat with the front PTO switched on with the tractor in
motion, an acoustic signal sounds and the front PTO switches off.
Front PTO shaft is equipped with a solid six or twent
y
-one
splined end point and it comes only in design of 1,000
revolutions.
Tractor may be equipped with front PTO shaft with varied
direction of spinning:
a - In compliance with the direction of engine
revolutions (standard)
b - Against the direction of engine revolutions
(*on request)
FCL20S5027
PTO revolutions speed is dependent on engine
revolutions. With the tractor stopped while the engine is
running:
A - Pressing the button on the right pillar of the cab for at
least one second puts the front PTO shaft into operation.
When pressing the button the operator must sit
on the driver's seat.
B - Rotation of the front PTO is indicated by the number of
revolutions on the dashboard. The mode of operation is
indicated by a pictogram on the dashboard display.
FHSX18N015
DRIVE OF AGRICULTURAL MACHINERY
142