Work Lights Memor
Automatic Work Lights Activation according to the Selected Driving Direction (FNR Automatics)
The key must be in position I for the FNR automatics to function properly.
Press and hold the ON / OFF button (1) to activate the 'FNR' automatics, which automatically turns on the
work lights according to the direction of travel of the tractor.
The activation of this function is indicated by the yellow ON / OFF button backlight.
The travel direction selector is located under the steering wheel on the right side. The shifted (selected)
direction of travel is then indicated on the instrument panel
When F (forward direction) is engaged, all work lights that are stored in the forward driving memory are
switched on automatically and the lights for reversing (if active) are deactivated.
Press and hold the corresponding button (2, 3, 4, 6, 7, 8, and 9) of the relevant light to switch on the relevant
light for the selected forward direction.
When R (reverse direction) is engaged, all the work lights stored in the memory for reversing are switched on
automatically and the lights for forward direction (if active) are deactivated.
Press and hold the corresponding button (2, 3, 4, 6, 7, 8, and 9) of the relevant light to switch on the relevant
light for the reversing.
Press the ON / OFF button (1) to turn on the work lights
memory; the backlight of the button changes to dark green
(functional backlight).
Press the relevant buttons to switch on the required
configuration of work lights.
Press the ON / OFF button (1) again to turn off the work
lights memory; the backlight of the button changes to light
green (orientation backlight). The work lights turn off and
their configuration is stored in the memory.
If the work lights memory is switched on by pressing (1)
button, all the work lights that were on when the work
lights memory was last switched off come on one after
another.
If the work light memory is switched on and we change the
configuration of work lights by switching on or off certain
lights using the relevant buttons (2, 3, 4, 6, 7, 8, a 9),
when the memory is switched off with the (1) button, the
new configuration of lights is stored and the work lights
turn off.
Saving is only active with the key switched on.
If the key is switched off, the new light configuration will
not be stored. The previously stored configuration is still
active.
If the light memory is on and the lights are switched on
and the key is switched off, all lights will go out
automatically after 5 minutes after the key has been
switched off.
C20N035
ACQUAINTANCE WITH THE TRACTOR
To Next Page
Loading...
