36
GETTING ACQUAINTED WITH THE TRACTOR
NM13N004 NM13N005 NM13N049
PTO SHAFT DRIVE ENGAGEMENT
LEVER
Rear PTO shaft is engaged by a lever (1)
placed on the left side of driver’s seat.
a -
Dependent revolutions of PTO
shaft drive through gear box –
revolutions are dependent on the
engaged gear
n -
neutral position
b -
Independent revolutions of PTO
shaft drive – revolutions are de-
pendent on engine revolutions
Gear shifting is done with a tractor at
standstill and engaged manual clutch
lever.
PTO SHAFT REVOLUTIONS 540 AND
1000 RPM SHIFTING LEVER
Shifting 540 or 1 000 revolutions of rear
PTO shaft is done with the lever (1)
placed from the outside of the tractor
above the rear PTO shaft.
a -
1 000 rpm
b -
540 rpm
Gear shifting is done with the lever of
PTO shaft drive engagement in (n) posi-
tion.
PTO shaft revolutions and the type
of endpoint need to be selected
dependent on the prescribed revo-
lutions of the aggregated machine.
BATTERY DISCONNECTOR
Battery disconnector (1) is placed on the
right side of the tractor in front of the cab.
a - Battery is connected
b - Battery is disconnected
With long-term dead parking, re-
pairs, a failure, or accident, dis-
connect the battery immediately
by battery disconnector.
To Next Page
Loading...
