54
TRACTOR RUN-IN
NM13N090 NM13N100
GENERAL PRINCIPLES OF NEW TRACTOR RUN-IN IN FIRST 100 HOURS OF
OPERATION
During first 100 hours of operation:
- Load tractor in a normal way, avoid operation with low or maximum engine revolu-
tions
- Avoid excessive idle run operation
- Check oil levels in engine often (during this time increased oil consumption is nor-
mal)
- Check screw joints in particular in supporting parts of tractor
- Learned insufficiencies to be removed immediately, you will thus prevent subse-
quent damage or endangered operation
- Keep the same procedure also after tractor complete overhaul
IN FIRST 10 HOURS OF OPERATION
- Perform run-in in traffic
- tighten fastening nuts of front and rear
wheels including connection bead / rim
with prescribed torque
To Next Page
Loading...
