96
AUXILIARY BALLAST WEIGHTS
E556 E557
FILLING TIRES WITH LIQUID PROCEDURE
1. by heaving the tractor relieve tire and turn the wheel valve
up (A)
2. let out air and unscrew the valve insertion
3. screw in the adapter for water filling, muzzle a hose for liq-
uid inlet
4. fill the tire with a prescribed amount of liquid
5. it is possible to use head tank (B) or you can do the filling
under pressure (C)
6. remove the hose and unscrew the adapter for water filling
7. screw in the insertion of a valve and inflate the tire to pre-
scribed pressure (D)
8. after inflating screw in a protective cap on the valve
9. fill the second tire in the same way
DRAINING LIQUID FROM TIRES PROCEDURE
1. by heaving the tractor relieve tire and turn the wheel valve
up (A)
2. let out air and unscrew the valve insertion, turn the wheel
valve down
When draining the liquid, there can be decompression
in the tire. Therefore turn the wheel a bit from time to
time to get the valve into upper position (B)!
3. remove remaining liquid after screwing in an adapter for fill-
ing with water by inlet of compressed air (C)
4. blow the liquid out for so long that the liquid stops flowing
out through the tube of air adapter
5. unscrew the adapter for water filling
6. screw back in the air part of valve and inflate the tire to pre-
scribed pressure (D)
7. screw in a protective cap to a valve
8. drain the liquid similarly also from the second tire
To Next Page
Loading...
