Leaving the tracto
Hydrostatic steering failure warning signalization
Important notification
Before leaving the tractor with a safety cab do not forget to
remove the key from the switch box in position '0' (only
with engine at standstill - charging control must be on) and
lock the cab. (The key cannot be pulled out in positions
I and II)
Tractor must be secured against spontaneous
drive away:
1. engine disengaged
2. 1
st
gear engaged
3. braked with the manual brake
If the tractor is on the slope wheels must be made stable
with shims.
NM13N062
Hydrostatic steering pump failure is with pressure drop
under 120 kPa behind the pump signalized on the
dashboard by an applicable symbol.
Note: When starting the engine or with low engine
revolutions, the control may be blinking, if after starting or
revolutions increase engine control goes out, it is not
a failure. The system is alright.
If greasing, charging or hydrostatic steering failure
controls light up, stop the engine immediately and contact
service. You will prevent a serious failure or tractor
accident.
To Next Page
Loading...
