ZETRON Model 16 - Page 74

SECTION 5 - DATA COMMUNICATIONS PROTOCOL
The Logon Sequence is:
Entry Device Paging Terminal Comments
"<CR>"
"ID=<CRxLF>"
"<ESC>PGlpppp<CR>" Select Internal Data Base Mode
or
"<ESC>PG8pppp<CR>" Select Full Capcode Mode
"pppp" is the four character
Security Code password. It
should be omitted if the
Security Code is disabled.
If it is required, it is
always 4 chars in length.
"<ACK><CR>< optional ><CR>"
Logon accepted
"<ESC>[p<CR>" Paging Terminal is ready
(left bracket, lower case "P")
or
"<NAKxCR>< optional ><CR>"
Logon requested again (from
the <ESC> sequence)
or
"<ESCxE0Tx optional xCR>"
Logon denied, Paging Terminal
disconnects.
5-2