EasyManua.ls Logo

ZEV electric motor scooter User Manual

Default Icon
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ZEV
Z ELECTRIC VEHICLE Corporation
ELECTRIC MOTOR SCOOTER AND
MOTOR CYCLE
OPERATING MANUAL
THANK YOU FOR PURCHASING A ZEV!!
VEHICLE IDENTIFICATION AND EPA AND DOT COMPLIANCE LABELS
The VIN number plate is located on the battery box rear above the rear wheel in a
tamper resistant area. This is also stamped into the frame on the right side.
The EPA and DOT information labels are located on the side of the battery box at the
back of the bike.
Question and Answer IconNeed help?

Do you have a question about the ZEV electric motor scooter and is the answer not in the manual?

ZEV electric motor scooter Specifications

General IconGeneral
BrandZEV
Modelelectric motor scooter
CategoryScooter
LanguageEnglish

Summary

INITIAL CARE AND FIRST RIDE PREPARATION

Parking Safety and Stability

Bike lacks parking brake; secure it on level ground or against a curb. Beware of hot asphalt.

CHARGING AND FIRST RIDE GUIDELINES

First Ride Essentials

Charge bike, check tires, wear safety gear, and consider a riding course.

OPERATING THE SCOOTER

Throttle Usage Warning on Hills

Avoid using throttle to hold bike on hills; use brakes to prevent motor damage.

HANDLEBAR CONTROLS AND BRAKES

Simultaneous Brake Application

Always use both front and rear brakes simultaneously for optimal stopping.

INSTRUMENTS, GAUGES, AND DAILY USE

First Drive Warning

Avoid maximum acceleration initially to preserve range and prevent damage.

RIDING CHECKS AND CHARGING

Pre-Ride Checklist

Check tires for pressure and damage, verify lights and horn, inspect brake fluid.

VEHICLE STANDS AND POWER MANAGEMENT

Hill Holding Warning

Do not use throttle to hold bike on hills; use brakes to prevent overheating.

UNDERSTANDING RANGE AND POWER

Factors Affecting Range

Strong acceleration, extra load, hilly terrain, and non-steady throttle reduce range.

Range Warning Signs

Monitor power gauge and listen for 'cut out' signals indicating low battery.

Battery and Controller Protection

Do not run battery dead; avoid pushing or forcing bike to prevent damage.

POWER LEVEL GAUGE AND VARIABLE CONTROL

Battery Cutoff and Charging

Avoid draining battery below cutoff; special charging needed if it occurs.

ELECTRICAL SYSTEM AND CLEANING

Battery Terminal Safety

Exercise caution around high amperage (300A) and voltage (120V) battery terminals.

Electrical System Precautions

Turn off breaker/key before electrical work; wait for capacitor discharge.

TRANSPORTING YOUR ZEV

Securing Bike for Transport

Use tie-down straps on luggage rack, swing arms, and front wheel.

TRANSPORT STRAPPING TECHNIQUES

Preventing Forward Movement

Strap swing arms backward at 45+ degrees to prevent forward motion.

Preventing Backward Movement

Strap swing arms forward at 45+ degrees to prevent backward motion.

TROUBLESHOOTING AND BATTERY DESTRUCTION

Common Non-Running Issues

Check battery charge, side kickstand position, and circuit breaker status.

FUSES AND FRAME PAINT

Battery Depletion Warnings

Bike may shift gears or shut down if battery is severely depleted.