EasyManuals Logo

ZF 45-1 User Manual

ZF 45-1
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
Operating Manual ZF/ZFE 25 A - ZF/ZFE 85 IV
7.1 Troubleshooting
First of all check, whether all items of operating instructions have been complied with.
SyMPTOM POSSIBLy CAUSED By REMEDy
1. High fluid temperatur Fluid level high Pump out fluid to max
during operation mark on dipstick
Fluid level low Add flui
Plugged or restricted Replace cooler and flush
fluid coole water system
No water in cooling Check cooling system
system and repair
Unknown Consult service station
2. Fluid on transmission housing Loose screws Tighten to specificatio
Loose screw connections Tighten, replace
Loose dipstick Tighten, replace
Loose fluid filt Tighten, replace
Fluid level high Pump out fluid to max.
during operation mark on dipstick
Unknown Consult service station
3. Fluid and water mixed Damaged fluid coole Consult service station
4. Shifts hard Selector control Consult service station
Linkage Adjust
Unknown Consult service station
5. Slow engagement Selector control Consult service station
Low fluid leve Add flui
Linkage Adjust
Unknown Consult service station
6. No movement of the boat Selector control Consult service station
Improper selector position Adjust
Low fluid leve Add flui
Propeller missing Replace
Propeller shaft broken Consult service station
Transmission malfunction Consult service station
Engine malfunction Consult service station
No electric supply to electric Plug to be fitte
valves (ZFE only) Consult service station
In case of emergency
«Get home» feature can be
used (see pag. 10).
3) Stop the engine and check oil level
again.
If necessary, replenish with oil.
Excessive oil should be removed.
The fluid level on the dipstick
should be between the min. and
max. marks.
The fluid level should be checked
again after a short driving period.
6.1.8 STORAGE
If the transmission is stored for longer
time, for example winter storage, it
should be topped off through the dip-
stick hole with ATF to prevent the unit
from corrosion.
CAUTION
Change the fluid when putting the
unit into operation again.
IT, EN, DE, FR, ES, NO, PT, NL, FI, EL, HR 3315.758.001 - 2018-04

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ZF 45-1 and is the answer not in the manual?

ZF 45-1 Specifications

General IconGeneral
BrandZF
Model45-1
CategoryEngine
LanguageEnglish

Related product manuals