Handbook Ucontrol type-lines PXDM Date 06/04
TBL02_55-GB06/04 Part.-No. 00153239-GB
Page 18 / 105
6.2 Menu operation and menu structure
After switching on the device or mains supply, the Start menu group appears in the display. One reaches the menu items
of this menu group by pushing the “P“ key. General settings and queries can be undertaken there. The desired
C o u n t r y l a n g u a g e, e.g., can be set for initial start-up operation here.
One moves up and down within the menu group using the arrow keys. One returns to the menu group using the ESC (↑ +
↓) shortcut keys (push the keys simultaneously). Selection of the menu group to the right through the down key, to the left
through the up key.
The menu groups consist of one area for the user (user menu) and one area for installation (service). The service area
can be protected against unauthorized access by using a PIN (Personal Identification Number). In order to simplify the
initial start-up operation, the service level is enabled at first (i.e., not protected by the PIN 0010
, see Controller Setup, PIN
protection = OFF). If PIN protection is activated (ON), the service menu remains enabled after input of PIN 0010
as long
as one is pressing keys. If no keys are pressed for ca. 15 minutes, the PIN is automatically erased, i.e. the service level is
blocked.
After installation of the device has been carried out, PIN protection should be activated!
The menu and its menu items are independent of the type of operating mode set. Here is a partial portrayal of the menus
for the factory mode of operation
1.01 speed controller.
PIN Protection OFF
PIN protection ON PIN 0010 necessary
User level Service level
To Next Page
Loading...
