Handbook Ucontrol type-lines PXDM Date 06/04
TBL02_55-GB06/04 Part.-No. 00153239-GB
Page 17 / 105
6. Controls and menu strukture
1 Multipurpose display
2 P-key (program key, open menu)
3 arrow -down-key (Menu down, reduce value)
4 arrow-up-key (Menu up, increase value)
5 ESC-key combination: arrow-down-key + arrow-up-key (Escape, leave menu)
6.1 Multipurpose LC display
The multipurpose LC display is specifically matched to this unit. If offers an optimum overview during adjustment and
control of the device. The display is inverted; i.e., the symbols and characters are luminously displayed with the amber-
colored background lighting. Through that, the display is always easily legible even during large distances and in dark
environments. In addition to the texts and numerical values, symbols are present that constantly display the device’s most
important operating conditions.
Application of the symbols is dependent on the type of device and the operating mode selected.
1 Moon-Symbol (set point 1 / 2, e.g. for day / night operation)
2 Arrow 1-Symbol (not in use)
3 Alarm-Symbol (fault indication)
4 Arrow 2-Symbol (not in use)
5 Fire-Symbol (heating operatioin)
6 Arrow 3-Symbol (not in use)
7 Antenna-Symbol (Remote-Control aktiv)
8 Arrow 4-Symbol (not in use)
9 STOP-Symbol (enable)
10 Bargraph (intern control output)
11 Text line 3 figures (Anzeige Einheit, etc.)
12 Text line 16 figures (Anzeige Menütexte, etc.)
13 Numeric display 5 digit (display values, time, etc.)
Display after turning on the mains voltage
Example for mode
1.01
After the keys have not been pushed for ca. 15 minutes, the device switches to the display of the current modulation
(when being operated as a speed controller) or during operative modes as a controller for control of currently active
sensor signals (actual value).
Switch-over between Start
and Fanlevel or actual value with the key shortcut for Escape (Esc = ↑ + ↓).
1
5
43
2
Automatically after approx. 15 Min.
+
= Esc
GHI
0123456789ABCDEF
STOP
1
12
11
13
2345678 9 10
To Next Page
Loading...
