Handbook Ucontrol type-lines PXDM Date 06/04
TBL02_55-GB06/04 Part.-No. 00153239-GB
Page 19 / 105
6.3 The menu groups
General functions
PIN Input for loading factory- and usersetting, open service menu, setting menu language,
Reset after fault, Query of the device software version
Display for modulation, settings, actal values, status for minimum speed cut off.
(settings are not possible in this group of menus)
Setting for operation
settings, Pband, Min. and Max. speed, manual operation,
Display and query of events and malfunctions
Base setup (Installation)
Selection mode of operation, Configuration of analog signal- and sensor
inputs
Service level User level
Controller Setup
Protection of the settings, message during sensor malfunctions ON /
OFF
Limitation of modulation, minimum speed cut off ON / OFF, group
control, reverse action of control function (Heating / Cooling), controller
configuration (P, PID)
IO Setup
Function and Inverting analog outputs, for digital inputs, for relay
outputs. Inverting of analog inputs. Setting Bus address for
network
djustable limit indication for:
modulation, analog input signal ,deviation between actual and
target
Motor Setup
setting for cos Phi, ramp up time and ramp down time,
suppression of speeds
Diagnostics
display of the internal temperature, height of the input
signal, status of digital inputs and relay outputs, line
frequency
To Next Page
Loading...
