ZIEHL-ABEGG Ucontrol PXDM35A - Controller Setup; Pin Protection

Handbook Ucontrol type-lines PXDM Date 06/04
TBL02_55-GB06/04 Part.-No. 00153239-GB
Page 73 / 105
9. Controller Setup
9.1 Pin protection
The adjustments for the installation in the service level can be protected against unintentional modifications. To do this,
activate the „PIN protection“. In order to simplify the initial start-up operation, the service level in the factory setting is free
– i.e. accessible without PIN 0010.
After installation of the device has been carried out, PIN protection should be activated!
9.2 Set protection
The „Settings” menu for the user’s basic settings (Setpoint, default value, min, max, ..) are freely accessible when using
the factory settings (i.e. without PIN). If necessary, these can also be protected against unauthorized modifications by
using a PIN (1234). For this, the settings protection must be programmed to „ON”. The settings menu is then no longer
visible without inputting a PIN!
Function only in combination with activated PIN protection!
↓P ↑ ESC
Start INFO Setting Events
Base setup ControllerSetup
IO
- - - -
PIN input
::: .
OFF
PIN-Protection
:::. :
User level Service level
PIN 0010 necessaryPIN Protection ON
PIN Protection OFF
Menu „Setting“ if Set-protection „ON“ only after PIN Input (1234) visible
Start INFO
Setting Events
::::
:::.
↓ ↑
↓P ↑ ESC