ZIEHL-ABEGG Ucontrol PXDM35A - Intern; Extern Function 6 D

Handbook Ucontrol type-lines PXDM Date 06/04
TBL02_55-GB06/04 Part.-No. 00153239-GB
Page 87 / 105
10.2.6 Intern / Extern Function 6D
¨ Switch over between Set Intern and Set Extern (for mode speed controller 1.01)
“Set external 1“ under settings must be programmed to OFF
contact at digital input e. g. Digital IN 1 = D1-D1
Set Intern 1 at opened contakt ↔ Set Extern at closed
contact D1 Inverting OFF
Set Intern 1 at closed contakt ↔ Set Extern at opened contact D1 Inverting ON
¨ Switch over between aktiv setting at the unit and external Signal (for mode controller higher 2.01)
Contact at digital input e. g. Digital IN 1 = D1-D1
External Setpoint at 1E
for E2 Function
External manual operation at 2E for E2 Function
Setting at the unit at opened contact ↔ Signal Extern at closed contact D1 Inverting OFF
Setting at the unit at closed contact ↔ Signal Extern at opened contact D1 Inverting ON
Signal 40%
Controller
3~ 400 V
3~ 78 % = Intern 1
D1 D1
0
1
0
1
3~ 40 % = Extern
E1
External
Setpoint
Si
g
nal 40 %
Controller
3~ 400 V
3~ 0-100 %
D1 D1
0
1
1
0
3~ 80 %
Sensor
E1
E2