Non-Sound Decoder MX600 - MX638 and Sound Decoder MX640 - MX659 Page 3
20 x 11 x 3.5mm Non-Sound - 1.0A - 6 Fu-Outputs - 2 Servos - SUSI DCC, MM, DC, AC
Compact HO loco decoder, for universal applications.
TYPICAL APPLICATION: HO. Due to excellent dielectric strength (50V), the de-
coder is also suitable for AC analog operation with the old Märklin transformers.
MX630 plug configurations:
9 highly flexible wires (120mm) for pick-up, motor and 4 function outputs. Solder
pads for 2 additional logic level outputs, servo outputs or SUSI.
MX630 with 8-pin plug as per NEM652 on 70mm wires.
MX630 with 6-pin plug as per NEM651 on 70mm wires.
MX630 with 16-pin PluX connector, mounted on circuit board.
Out of production since December of 2012; replaced by MX634.
28 x 15.5 x 4mm Non-Sound - 1.6A - 8 Fu-Outputs - 2 Servos - SUSI DCC, MM, DC, AC
High output decoder, with built-in energy storage circuitry.
TYPICAL APPLICATON: HO, O and similar gauge, especially for vehicles with
low-voltage bulbs (1.5 or 5V).
MX632 plug configurations:
11 highly flexible wires (120mm) for pick-up, motor and 4 function outputs. Sol-
der pads for 4 additional logic level outputs, servo outputs or SUSI.
MX632 with 8-pin plug as per NEM652 on 70mm wires.
MX632 with 21-pin “MTC“ plug mounted on decoder board.
As MX631D but for Märklin, Trix or similar; FO3, FO4 as logic level outputs.
Decoders with low voltage supply for function outputs:
...V = 1.5V, ...W = 5V, ...VD or ...WD = with 21-pin plug.
22 x 15 x 3.5 mm Non-Sound - 1.2 A - 10 Fu-Outputs - 2 Servos - SUSI DCC, MM, DC, AC
Decoder with 10 functions, large processor and energy storage circuitry
TYPICAL APPLICATON: HO and O gauge, if lots of functions are required, al-
so: this is the only (first) HO decoder usable with gold caps!
MX633 plug configurations:
11 highly flexible wires (120mm) for pick-up, motor and 4 function outputs. Sol-
der pads for 6 additional outputs, logic level, servo outputs as well as SUSI.
MX633 with 8-pin plug as per NEM652 on 70 mm wires.
MX633 with 22-pin PluX connector mounted on decoder board.
20.5 x 15.5 x 3.5 mm Non-Sound - 1.2 A - 6 Fu-Outputs - 2 Servos - SUSI
H0-Decoder, with large processor (as MX63)and energy storage circuitry
TYPICAL APPLICATON: HO and (smaller) O gauge.
MX634 plug configurations:
MX634 with 21-pin “MTC“ plug mounted on decoder board.
MX634D but for Märklin, Trix or similar; FO3, FO4 as logic level outputs.
26 x 15 x 3,5 mm Non-Sound - 1,8 A -10 Fu-Outputs - 2 Servos - SUSI - DCC, MM, DC, AC
High performance-decoder, with energy storage circuitry,
Low heat production because of synchronous rectifier,
Types with low voltage supply for Fu-outputs.
TYPICAL APPLICATION: HO, gauge O.
MX634 plug configurations:
MX635
MX635R
MX635P22
MX635V
MX635W
11 Anschlussleitungen (120 mm) für Schiene, Motor, 4 Fu-Ausgänge, Löt-Pads
für 6 weitere Fu-Ausg., Logikpegel-Ausgänge, Servo-Steuerleitungen, SUSI.
Wie MX635, with 8-pin plug as per NEM652 on 70mm wires.
Wie MX635, with 6-pin plug as per NEM651 on 70mm wires
Ausführungen mit Niederspannungsversorgung für die Fu-Ausgänge:
… V - 1,5 V … W - 5 V
26 x 15 x 3.5 mm Non-Sound - 1,8 A - 6 Fu-Outputs - 2 Servos - SUSI - DCC, MM, DC, AC
High performance-decoder, with energy storage circuitry,
Low heat production because of synchronous rectifier,
Types with low voltage supply for Fu-outputs.
TYPICAL APPLICATION: HO, gauge O.
MX636 plug configurations:
MX636D
MX636C
MX636VD
MX636VW
.WIth 21-pole “MTC“ - interface mounted on decoder board.
As MX636D, abut FA3, FA4 as logic leven outputs
Version with low voltage supply for Fu-outputs:
… V - 1,5 V … W - 5 V
22 x 15 x 3.5 mm Non-Sound - 1,0 A - 9 Fu-Outputs - 2 Servos - SUSI - DCC, MM, DC, AC
HO decoder only with PluX-22 interface
20.5 x 15.5 x 3.5 mm Non-Sound - 1,0 A - 6 Fu-Outputs - 2 Servos - SUSI - DCC, MM, DC, AC
HO decoder only with PluX-22 interface MTC-21 (21MTC)
To Next Page
Loading...
