ZipZaps micro RC User Manual

It’s the ultimate radio control experience! Your Starter Kit comes with a radio controller and a full set of
factory parts to assemble your car. With a quick charge about 60 seconds, your ZipZaps micro RC will
be revving in no time.
Your ZipZaps micro RC provides totally 6 selectable channels. You can enjoy racing with 6 cars a time.
Your ZipZaps micro RC comes with a built-in Ni-MH rechargeable battery to power the car, and it
requires four AAA batteries (not supplied) for the controller/charger.
Built to 1:64 scale, your tunable ZipZaps micro RC is small enough to carry in your pocket. ZipZaps are
perfect for anyone ages 8 and up.
To really rev up the fun factor, you can customize your ZipZaps micro RC with optional performance
upgrade kits, available at the ZipZaps Showroom at www.zipzaps.com
(Please confirm this) and your
local RadioShack. Just follow these steps to get your car up to speed and ready to race.
1 Starter Kit Includes
Your ZipZaps micro RC Starter Kit includes everything you see here:
Factory parts.eps here
2 Attach the WRIST STRAP
Attach the WRIST STRAP as shown below to prevent dropping your CONTROLLER. Thread the string
through the hole on the left side of the CONTROLLER as show, and then thread the strap through the
ring of the string.
Attach strap.eps here.
3 Powers Up Your Controller
The CONTROLLER charges your micro RC and controls its steering and speed. You’ll need to install
four AAA batteries. For the best performance and longest life, the ZipZaps factory recommends
RadioShack Enercell Plus alkaline batteries.
RELEASE
ON OFF
ON OFF
ON OFF
ON OFF
OPEN
OPEN

ZipZaps micro RC Specifications

General

Type	Micro RC Car
Scale	1:64
Control	Radio Control
Channels	2
Speed	5 mph (estimated)
Battery	2x AAA (controller)