7KHIROORZLQJFKHFNVDUHVXJJHVWHG
Before your ride, check:
> :KHQ\RXDUHULGLQJALWAYSXVHDELF\FOHKHOPHWIRU\RXUVDIHW\
> 6HWUHIOHFWRUVRQ\RXUELF\FOHIROORZLQJWKHOHJDOUHTXLUHPHQWV
ZKHQ\RXULGHRQWKHSXEOLFURDG.
> %LF\FOHORDGVKRXOGEHOHVVWKDQ/%6300 LBS for the Forte)
Load Limit is defined as RIDER + ANY GEAR CARRIED BY BIKE.
> &RQILUPWLUHVDUHLQIODWHGWRFRUUHFWSUHVVXUH,QGLFDWHGRQVLGHZDOO
RI WLUH$OVRFKHFNWKHFRQGLWLRQRIWLUHVIRUFXWVHWF1RWHIt is a good
idea tocarry a puncture repair kit and spare inner tube).
> Handlebar, stem and headset locknut are tight and that the
steeringturns smoothly.
MECHANICAL MAINTENANCE:
It is extremely important that your bike is checked and serviced
at regular intervals to ensure reliability andthat it is safe to ride.
&OHDQLQJ DQG OXEULFDWLRQ is DOVR DQ LPSRUWDQW step LQ WKH
SURSHUPDLQWHQDQFHRI \RXU ELNH 7KLVLV FRYHUHG LQPRUHGHWDLO
LPPHGLDWHO\DIWHUWKLVVHFWLRQ
Some servicing and repair tasks require specialized
knowledge and tools. Improper adjustment may damage
the bike or lead to a serious injury to the rider. If you
have any doubts about properly adjusting your bike,
consult our Service Department or your local bike shop.
WARNING:
Failure to correctly tighten the frame latch can
lead to damage to the bicycle or injury to the
rider. Do NOT ride with a loose frame hinge.
> Brakes - Squeeze levers to ensure sufficient pressure can be
applied without the lever touching the handlebars. Also ensure
brake pads are aligned correctly with WKHrim and the brake pads
arenot badly worn.
> Brakes cables are not frayed at the ends or at the pinch bolts
> *HDUVRSHUDWHFRUUHFWO\DQGVPRRWKO\
> :KHHOVDUHUXQQLQJWUXHE\VSLQQLQJWKHP
> 7KHKHLJKWRIWKHVHDWFDQEHDGMXVWHGIURP7 LQFKHVWR6 inchHV
(0HDVXUHGIURPWKHVHDWUDLOVWRWKHWRSRIWKHVHDWWXEH)
> $IWHUORQJRUKDUGULGHVRUDIWHUHYHU\PRQWKRIUHJXODUXVH&KHFN
WKHSUHYLRXVSRLQWVSOXVWKHIROORZLQJ
> &OHDQGHJUHDVHDQGOXEULFDWH\RXUELNH
> &UDQNERWWRPEUDFNHWILWWLQJDQGSHGDOVDUHWLJKW
> 7LUHZHDUDQGJHQHUDOWUHDGFRQGLWLRQ/RRNIRUFXWVJODVV7KRUQV
HWFLQWLUHV
> &RQILUPVpokes are not loose or broken. These need to be attended
to beforethe bike can be ridden again and you would probably need
to getthese corrected at the local bike shop.
> Hubs are running smoothly.