Zlin Aircraft Z-526 Akrobat User Manual

SPECIFICATIONS
Wingspan:......................................1610mm
Length:...........................................1190mm
Electric Motor:.....................See next pager
Glow Engine:.................... .46 2-T / .70 4-T
Radio:....................7 Channel / 7 Servos
Function: Ailerons-Elevator-Rudder-Throttle
Flaps-Optional Retractable Landing Gear.
WARNING! This radio controlled model is NOT a toy. If modified or flown carelessly it could go out of controll and
cause serious human injury or property damage. Before flying your airplane, ensure the air field is spacious enough.
Always fly it outdoors in safe areas and seek professional advice if you are unexperienced.
ACHTUNG! Dieses ferngesteuerte Modell ist KEIN Spielzeug! Es ist für fortgeschrittene Modellflugpiloten bestimmt,
die ausreichende Erfahrung im Umgang mit derartigen Modellen besitzen. Bei unsachgemässer Verwendung kann
hoher Personen- und/oder Sachschaden entstehen. Fragen Sie in einem Modellbauverein in Ihrer Nähe um
professionelle Unterstätzung, wenn Sie Hilfe im Bau und Betrieb benötigen. Der Zusammenbau dieses Modells ist
durch die vielen Abbildungen selbsterklärend und ist für fortgeschrittene, erfahrene Modellbauer bestimmt.
Radio Control Model / Flugmodell
ALL BALSA, PLYWOOD CONSTRUCTION AND ALMOST READY TO FLY
Instruction manual / Montageanleitung
TECHNISCHE DATEN
Spannweite:...................................1610mm
Lange:............................................1190mm
Elektroantrieb.............(siehe nächste Seite)
Verbrennerantrieb:...............7.45cc - 11.5cc
Fluggewicht:.......................................3.2Kg
Fernsteuerung..........7 Kanal / 7 Servos
RTF Weight: 3.2Kg (will vary with equipment
use)
ZLIN
Z-526 Akrobat

Zlin Aircraft Z-526 Akrobat Specifications

General

Brand	Zlin Aircraft
Model	Z-526 Akrobat
Category	Toy
Language	English

Summary

Wing Halves Joining

Assemble Wing Halves

Guide to joining the two wing halves using epoxy, ensuring proper alignment and dihedral.

Engine Mounting Preparation

Prepare and Mount Engine

Steps for marking, drilling the firewall, and mounting the engine using bolts and blind-nuts.

Engine Installation

Mount Engine to Mount Beams

Instructions for positioning the engine, drilling mounting holes, and securing it with screws.

Fuel Tank Assembly

Install Fuel Tank and Check for Leaks

Steps for assembling the fuel tank, checking for leaks, and securing it in the model.

Electric Motor Mount Preparation

Prepare Plywood Motor Mount

Steps for marking and drilling the plywood motor mount using an aluminum plate as a template.

Electric Motor Mounting

Mount Electric Motor to Mount

Instructions for positioning the electric motor on the mount and securing it with screws.

Horizontal Stabilizer Fitting

Prepare and Fit Horizontal Stabilizer

Instructions for cutting covering, fitting, aligning, and marking the horizontal stabilizer.

Servo Linkage Connection

Connect Servo Linkages

Steps for connecting elevator and throttle servos to their respective pushrods.

Center of Gravity Adjustment

Achieve Correct Center of Gravity

Note on adjusting the battery pack location to achieve the correct Center of Gravity (CG).

Control Surface Throws

Adjust Control Surface Throws