10
Step 3: Check Water Supply Requirements and Cautions
The hot water supply line pressure must be between 0.04-1MPa.
Adjust the water heater to deliver water between 120°F ~149°F.
The dishwasher must be connected to a hot water supply between
120°F~149 °F. This temperature range provides the best
washing result and shortest cycle time. Temperature should not
exceed 149°F to prevent damage to dishes.
Ensure that the water supply valve is turned off before connecting the hot
water supply line to the dishwasher.
Seal the hot water supply line connections using teflon tape or sealing
compound to stop any water leakage.
When you install the dishwasher, ensure there is nothing on the drain hose
and be careful not to tear it during the installation process.
Figure 2
installing the dishwasher
To Next Page
Loading...
