10
Electrical Connection
• Only a qualified electrician who takes the appropriate regulations into account
may install the socket or replace the connecting cable. If the plug is no longer
accessible following installation, an all-pole isolating switch must be present on
the installation side with a contact gap of at least 1/8”. Contact protection must
be ensured by the installation.
• Touching some of the internal components can cause serious personal injury or
death. Do not disassemble this appliance. Improper use of the grounding can
result in electric shock. Do not plug into an outlet until appliance is properly
installed and grounded.
• A short power-supply cord is provided to reduce the risks resulting from
becoming entangled in or tripping over a longer cord.
WARNING
WARNING: We do not recommend using an extension cord and if used
on this appliance, it will void warranty. If you are going to use an extension
cord, make sure the wire gauge and length are correct for use with a
microwave. The use of an extension cord can cause voltage drop, fire
hazard, and can cause permanent damage to the microwave if used.
• Longer cord sets or extension cords are available and may be used if care is
exercised in their use.
• If a long cord or extension cord is used:
• The marked electrical rating of the cord set or extension cord should be
at least as great as the electrical rating of the appliance.
• The extension cord must be a grounding-type 3-wire cord.
• The longer cord should be arranged so that it will not drape over the
counter top or tabletop where it can be pulled on by children or
tripped over unintentionally.
ELECTRICAL REQUIREMENTS:
• A three prong grounded outlet
• 120 V, 60 Hz, AC only
• 20 Amp electrical supply with a fuse or a circuit breaker
BEFORE INSTALLATION
To Next Page
Loading...
