HOW TO INSTALL
6
Last, adjust the slope of the lens by twirling the
cameras up and down, left and right to make sure
that the front of the Main Body is facing the camera’s
monitoring area. There are two focus screws in the rear of
the camera for you to adjust your lens.
step
Attach the Main Body to the mounting location
using the 4 screws supplied in your package. As
shown in the picture, push the 4 screws into the four
holes at the end of the camera Mount Bracket, then twist
them into the holes on the wall using screwdriver.
Note
There are three screws on the front end of the camera
Mount Bracket. With the screws on the two sides, you
can adjust the cameras up and down, and with the screws
under it, you can adjust the cameras left and right to make
sure that the camera is facing the monitoring area.
step
2
3
Building NO.5, Shaer Bluesky Science and Technology Park,
Shajing,Baoan District,Shenzhen
Fax: Tel: 0755-3392-6029 0755-3392-5683
To Next Page
Loading...