System Settings
Use this menu to view and change basic settings and information of the NVR.
From this menu, you may enable the startup guide, change the display resolution,
view system information, upgrade the NVR firmware and reset the system to
factory default settings.
Startup Guide Check this box to enable the startup guide to appear (refer to 3.3
NVR First-time Startup). The startup guide will appear the next time the system
is powered on.
Please refer to the following instructions to upgrade the firmware from the
system (required: a USB drive).
1. Download the updated firmware from the website on your computer.
2. Place the file onto a USB drive.
3. Connect the USB drive to the USB port on your NVR.
4. Go to the General Settings menu in the Main Menu and access the
Version/Upgrade page.
5. Select "Upgrade" and wait 5-10 minutes.
To Next Page
Loading...