COMPONENTS/HANDLING INSTRUCTIONS/
CONTROL PANEL
- 4 -
Component/
Handling Instructions/
Control Panel
Components
Handling Instructions
Kneading Blade
Baking Pan
Viewing
Window
Steam Vent
Main Body
Flange
Rotating Shaft
Lid
Control Panel
Power Supply
Cord
Plug
Heating Element
Safety Device
For safety reasons, the unit will not
operate unless the lid is closed.
At no time should anything be
pushed into the safety device
holes as this may result in injuries
or unit malfunction.
Removing the baking pan: Installing the baking pan: Attaching the kneading blade:
Grasp the baking pan’s shorter
flanges and pull toward you to
unlatch the spring. Then lift to
remove. Use oven mitts for
removing a hot pan.
Hold the baking pan’s shorter
flanges and place it right in the
center of the oven cavity. Press
down until it clicks into place.
Attach the kneading blade to the
rotating shaft and push down
firmly.
Be sure to attach the
kneading blade securely.
To Next Page
Loading...
Need help?
General
