ZOOM G9.2tt
10
Quick Guide 1
(Play Mode/Manual Mode Operation)
This section explains various basic steps, allowing you to use the G9.2tt right away.
É¡
Ch.AB
É™
BpmTp
AmpDrive
™LVL100
U0
Selecting a patch (play mode)
HINT
You can switch the
group/bank by turning the
[TYPE] knob.
NOTE
In manual mode, the foot switches do not select
patches. However, the [TYPE] knob (group/bank
selection) and parameter knob 1 (patch selection)
function the same as in play mode. Note that when
you switch a patch, the unit returns to play mode.
HINT
Group name/Bank number
[Indication in play mode]
Patch name
Patch level
Immediately after power-on, the unit will be in play mode.
In manual mode, you can use foot switches 1 - 5 to
switch a module on and off.
You can switch patches within the
same group/bank. The number of
the currently selected patch can be
checked by checking which foot
switch LED (1 - 5) is lit.
Turning a module on and off
with your foot (manual mode)
Function foot switch 2
assignment
Function foot switch 1
assignment
• You can switch patches within the
same group/bank by turning
parameter knob 1.
• You can adjust the patch level
(output level of the individual patch)
by turning parameter knob 2.
The G9.2tt switches to manual mode.
2. To select a patch from
another group/bank, use
the BANK [W]/[Q] foot
switches to select the
group/bank and then use
foot switches 1 – 5.
1. To select a patch, use
foot switches 1 – 5.
1. In play mode, keep the BANK [W] foot
switch depressed for more than one
second.
Quick Guide 1 (Play Mode/Manual Mode Operation)
ZOOM G9.2tt
11
ɡCh.AB əBpmTp
AmpDrive ™LVL100
U0
Pre-amp operation
HINT
NOTE
2. Press the foot switch for the module to be switched on and off.
3. To return to play mode, press the BANK [W] foot switch.
[Foot switch and corresponding modules]
WAH/EFX1 module
DELAY modulePRE-AMP module REVERB module
MOD/EFX2 module
The changes that you have made to a patch
will be lost when you select another patch. To
keep the changes, store the patch first (→ p.
13).
You can switch between channel A and B
with function foot switches 1 or 2 (→ p. 38).
2. Turn the knobs of the pre-amp section to
make adjustments.
When you operate a knob, the name of the
parameter and the current setting value appear on
the display. To return to play mode (or manual
mode), press the [EXIT] key.
1. Select the channel for which to make a
setting with the [PRE-AMP A/B] keys.
The pre-amp section
allows you to adjust
distortion type,
intensity, and EQ for
two channels (A/B)
separately.
The key light shows which channel is currently
selected.
[Pre-amp section]
[GAIN] knob [BASS] knob [TREBLE] knob
[AMP TYPE] knob
Distortion type
[LEVEL] knob [MIDDLE] knob [PRESENCE] knob
Pre-amp
module
output level
Mid range
boost/cut
High range
boost/cut
Low range
boost/cut
Distortion
intensity
Ultra-high
range boost/cut
To Next Page
Loading...
