Recording
Adjusting the volume display size to make checking
easier
The M4 records using 32-bit float format, making input gain adjustments unnecessary. Depending on the
input signal, however, the volume shown on the display could be too small or too large, making it difficult
to check.
By changing volume amplifications shown on the display, sizes can be adjusted to make each input easy to
check.
Moreover, the sizes of waveforms shown during recording also change recorded volumes.
1. On the Home Screen, select the input for changing volume amplification. (→Selecting inputs for
making settings)
2. Use and to adjust the size to make the volume easy to check.
The amplification can be checked with below the volume display.
NOTE:
• The volume display size can be adjusted to 31 levels.
• Be careful with the volume if you are monitoring the input sound with headphones, for example.
• Adjusting the amplification during recording will not affect the recording level of that recording.
48
To Next Page
Loading...
