Zoom player 3000 - Using the RP01 for Delay Tap Input or; Hold Delay Operation (DELAY Mode)

35 ●
This section describes how to use the RP01 for operating the DELAY mode.
Before connecting the RP01, make sure that the 3000 is turned off.
Connecting the pedal while the 3000 is on can lead to malfunction.
• When the selected patch uses the NORMAL or ANALOG effect type,
tap input of delay time is possible.
• When the selected patch uses the HOLD effect type, hold delay
operation is possible.
DELAY MODE LED lights up when the DELAY module of the 3000 is on
and flashes when it is off.
• Operation is the same as when using the FUNCTION switch on the
3000. The STATUS LED serves as function LED. For details, please
refer to "Setting Delay Time With Foot Switch" on page 21 or "Using
Hold Delay" on page 22.
• When the RP01 is connected and DELAY mode is selected, delay
time tap input or hold delay operation cannot be carried out
with the FUNCTION switch on the 3000, also if the FUNCTION
switch mode is set to "3: DELAY (TAP&HOLD)".
* When the RP01 is in DELAY mode, the Control pedal can be
used to adjust the balance between delay sound and original
sound. The integrated switch can be used to turn delay on and
off.
NOTE
NOTE
MODE SELECT
MODE DELECT
DELAY MODE (PEDAL SW TRIGGER)
RTM MODE
DELAY MODE LED lights when
DELAY module of 3000 is on.
Push the Mode Selector
Push the Mode Selector
STEP
1
Verify that the RP01 is properly connected to the 3000.
STEP
2
Select a patch for which the DELAY effect module is on.
STEP
3
Push the Mode Selector of the RP01 to select DELAY mode.
STEP
5
To return to the RTM mode, press the Mode Selector once more.
STEP
4
Use the foot switch on the RP01 to perform tap input of the delay time, or perform
hold delay operation.
ADVANCED GUITAR EFFECTS PROCESSOR
Using the Remote Pedal
Using the RP01 for Delay Tap Input or Hold Delay Operation (DELAY Mode)