Zoom R16 - Track Recording Procedures; Creating a New Project for Recording; Connecting Instruments and Setting Inputs

9
Audio interface manual
Fader section operation
By using the faders and status keys of the R16 fader section, you can control the volume and
muting,pauserecordingandswitchsoloonandointhecorrespondingCubaseLEtracks.
Operating the fader section
1
Assign the desired Cubase LE
tracks (channels) to the fader
section.
About banks
After setting up control surface operation, the
main parameters of Cubase LE can be operated
using the R16’s fader and status keys.
A group of tracks operated by the faders and
status keys is called a "bank," and one bank
includes 8 tracks.
For example, if fader 1 is assigned to Cubase LE
track 1, tracks 1-8 can be operated as shown in
the following diagram.
As the diagram shows, pressing the [9~16tr
(Bank>)] key once switches the allocations as
shown below.
Control 1 2 3 4 5 6 7 8
Track Tr.9 Tr.10 Tr.11 Tr.12 Tr.13 Tr.14 Tr.15 Tr.16
[1-8Tr] Key (< BANK)
Tracks (channels) assigned to the fader section
are moved backward by eight tracks.
[9~16Tr] Key (BANK >)
Tracks (channels) assigned to the fader section
are moved forward by eight tracks.
2
Use the faders to control the
volumes of the corresponding
tracks.
The faders control the volumes of their
respective tracks. Change the master
volume by moving the [Master] Fader.
Control 1 2 3 4 5 6 7 8
Track Tr.1 Tr.2 Tr.3 Tr.4 Tr.5 Tr.6 Tr.7 Tr.8