14
Audio interface manual
The mixer in audio interface mode
In audio interface mode you can make a mix for monitoring using the R16’s internal mixer. In
addition, you can adjust the balance of the internal mixer and the sound from the computer.
NOTE
The R16 REVERB SEND, PAN, VOLUME and
STEREO LINK settings are all saved when you
terminate audio interface mode and can be used
again the next time by choosing [CONTINUE] when
you relaunch audio interface mode.
You can be adjust the REVERB SEND, PAN,
VOLUME and STEREO LINK settings as in
recorder mode.
Operation is the same as in recorder mode.
(Reference: OPERATION MANUAL P.37)
The PAN/EQ Menu
Input1
VOLUME=0
VOLUME
You can set the volume levels for INPUT 1~8 between
0~127 (increments of 1). 100 is the default.
This is the rst menu item displayed when you push the
[PAN/EQ] key in audio interface mode.
Input1
REVERB SEND=0
SEND REVERB
You can change the reverb send levels for INPUT 1~8
from 0~100 (increments of 1) with 0 as the default (same
as in recorder mode).
Reverb only affects the monitored signal.
Input1
|-----+---|-|
PAN (BALANCE)
You can change the pan for INPUT 1~8 between
L100~R100 (increments of 2) with C (center) as the
default (same as in recorder mode).
Input1
STEREO LINK On
Link even and odd numbered INPUTS to handle them
as a stereo pair.
On/Off with “Off’ as the default.
By setting up a stereo link, REVERB SEND, PAN and
VOLUME track parameters can be applied to even and
odd inputs simultaneously. The odd numbered fader
will be active (same as in recorder mode).
(Reference : OPERATION MANUAL P.20 )
Volume, reverb send and pan
[BALANCE]
In audio interface mode the balance of the
signals monitored from the inputs and the signals
returning from the computer can be adjusted
with the [BALANCE] knob.
Left
Only the signals
from INPUT 1~8
Right
Only the DAW
stereo signal
STEREO LINK
To Next Page
Loading...
