Zoom R16 - Tool Functions; Tuner Usage and Instrument Settings; Metronome Configuration and Output Options

17
Audio interface manual
Working with patches
After you have made many edits, you might want to restore pre-edited settings by initializing the
patch. This will return it to its factory preset condition.
HINT
Even if you have not imported patches the initial
settings of patches that were used in the recorder
mode can be used.
1
Press
or
Turn EFFECT On if Off
press [ENTER].
If “EFFECT Off” is displayed,
Patch initialization (factory reset)
EFFECT> select patch> PATCH INITIAL
Change
menu
3
Press [ ].
No.00:Standard
>
EDIT
CLEAN <IN1>
No.00:Standard
2
Select algorithm/patch.
Change
menu
PATCH
Initial?
5
Conrm.
Press [ENTER].
Select
>PATCH INITIAL
.
4
Press [ENTER].
No.00:Standard
>
PATCH INITIAL
No.00:REVERB
>
PATCH INITIAL
Change
menu
Send return effect (only reverb) example
Insert effect example
Select an insert effect or send return
effect
patch
Press either INSERT EFFECT or SEND RETURN
EFFECT and select a patch from an algorithm.
(Reference: OPERATION MANUAL P.48)
Patch editing and renaming (EDIT)
By adjusting the effect module parameters you can set
it to create the desired result. You can also change the
name.
(Reference: OPERATION MANUAL P.53)
Importing patches (IMPORT)
All algorithms (as well as reverb patches) from the
effects of the project selected on the R16 can be
imported and saved as a single patch.
(Reference: OPERATION MANUAL P.54)
*In the audio interface mode, one complete set of effect
data is saved for the mode. There are no project based
settings.
Saving patches (SAVE)
Adjusted patches can be saved.
(Reference: OPERATION MANUAL P. 53)
Initializing patches (INITIAL)
Restores patches to their original factory settings (only
available in audio interface mode).
Patch operation menus
Patch operations
For both insert and send return effects