Zoom R16 - Panel Layout and Functions; Overview of Rear, Input, and Right Side Panels; Control, Fader, and Transport Section Details; Display Information and Indicators

5
Audio interface manual
Connecting and disconnecting in audio interface mode
Reference: “Cubase LE Startup Guide”
Install/setup details
This is a brief overview of connecting and disconnecting when a computer is hooked to the R16
by USB cable. For details, please refer to the separately attached “Cubase LE Startup Guide”.
Connecting the R16 to the
computer for the rst time
Connect the R16 to the computer.
R16 setup and connection
Setup DAW software
Device setup
Install Cubase LE DAW software
on the computer
1 1
Press [USB].
USB
>AUDIO INTERFACE
Change
menu
Press [Enter].
Select
>AUDIO INTERFACE
.
Download the latest ZOOM R16 /
R24 audio driver from the ZOOM
website (see below).
2
2
SETTING?
[CONTINUE] RESET
Change
menu
Press [Enter].
Select “Continue.”
4
AUDIO INTERFACE
Enter?
Press [Enter].
Verify.
Install the audio driver on the
computer.
3
5
4
3
R16 setup and connection
Follow these procedures from the second time connecting
NOTE
The ZOOM R16/R24 audio driver is essential
for using the R16 as an audio interface for DAW
software such as Cubase LE.
When downloading, follow the included instruction
guide to install correctly.
Please download the latest R16 audio
driver from Zoom Corporation’s website
at (http://www.zoom.co.jp).
NOTE
• Settherecordingquantization (bitdepth) of
Cubase LE or the DAW software that you are
using to 24-bit in order to achieve the best audio
qualitywhenrecording.(Seethesoftwaremanual
for how to make this setting.)
Control surface setup (Mackie Control) P.7
☞
Reference: "Cubase LE Startup Guide"