Zoom R8 - Operation Workflow Overview; Recording Preparations and Process

10
Audio interface manual
Using control surface functions
When using the connected by USB as an audio interface, the keys and faders
can be used to control Cubase LE’s transport and mixer.
HINT
Assigning keys
For a list of functions that can be assigned to the
knobs and keys of the
, as well as other trans-
port/function keys that are supported by Cubase
LE, please consult the “Control surface functions
quick reference guide” in this manual
About the control surface Control surface setup
In control surface mode, the keys and knobs
on the
can be assigned to particular
Cubase LE functions.
5
Then, launch Cubase LE.
Transport section P.11
About banks P.12
Fader section P.12
☞
Reference: Control surface functions quick
reference guide
P.15
6
From the Cubase LE “Devices”
menu, select “Device setup…”
Open the “Device Setup…” window.
7
At the top left of the Device setup
window [+], [−] and [|<] buttons
appear. Click the [+] and select
“Mackie Control”
8
Set the MIDI input and output
MIDI input: ZOOM R8
MIDI output: ZOOM R8
See setup and connection on P.8-9