ZooZ S2 STICK User Manual

FACTORY RESET
The S2 stick can only be reset by the host soware while
it’s in SerialAPI mode. The device is reset once an
appropriate command from the host soware is sent to
reset the Z-Wave network.
There is no way to manually reset the S2 stick if it’s not
controlled by host soware.
S2 STICK AS SECONDARY CONTROLLER
You can use the S2 stick as a secondary controller with
your existing Z-Wave system if it accepts additional con-
trollers. To enroll the S2 stick in your current system,
send the inclusion command and put the S2 stick into
learning mode, using the SerialAPI mode.
WARNINGWARNING
Ÿ This product should be installed indoors upon
completion of any building renovations.
Ÿ Do not install the S2 Stick in a place with direct sun
exposure, high temperature, or humidity.
Ÿ Keep away from chemicals, water, and dust.
Ÿ Ensure the device is never close to any heat source or
open flame to prevent fire.
Ÿ Ensure the device is connected to an electric power
source that does not exceed the maximum load power.
Ÿ No part of the device may be replaced or repaired by
the user.
This product is covered under a 12-month limited
warranty. To read the full warranty policy or file a
warranty claim, please go to:
www.getzooz.com/warranty
FCC NOTE
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO
THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT. STORE INDOORS WHEN
NOT IN USE. SUITABLE FOR DRY LOCATIONS ONLY. DO NOT
IMMERSE IN WATER. NOT FOR USE WHERE DIRECTLY EXPOSED TO
WATER.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following conditions:
1. This device may not cause harmful interference,
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used according to instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in
any given installation.
If this equipment causes harmful interference to radio or television
reception, the user may try to correct the interference by taking
one or more of the following measures:
- Reorient or relocate receiving antenna
- Increase the separation between equipment and receiver
- Connect equipment into a separate outlet or circuit from receiver
- Consult the dealer or an experienced radio/TV technician for
additional assistance
All brand names displayed are trademarks of their respective
holders.
© Zooz 2018
WARRANTY
This product can be included and operated in any Z-
Wave network with other Z-Wave certified devices from
other manufacturers and/or other applications. All non-
battery operated nodes within the network will act as
repeaters regardless of vendor to increase reliability of
the network.
This product features the latest Security 2 (S2) framework
to remove smart home network hacking risks. This de-
vice is equipped with a unique authentication code for
trusted wireless communication.
S2

ZooZ S2 STICK Specifications

General

Brand	ZooZ
Model	S2 STICK
Category	Modem
Language	English