9 
For this device, the highest reported SAR value for usage 
against the head is 0.638 W/kg, for usage near the body is 
1.169 W/kg.   
While there may be differences between the SAR levels of 
various phones and at various positions, they all meet the 
government requirements. 
SAR compliance for body-worn operation is based on a 
separation distance of 10 mm between the unit and the human 
body. Carry this device at least 10 mm away from your body to 
ensure RF exposure level compliant or lower to the reported 
level. To support bodyworn operation, choose the belt clips or 
holsters, which do not contain metallic components, to 
maintain a separation of 10 mm between this device and your 
body. 
RF exposure compliance with any body-worn accessory, 
which contains metal, was not tested and certified, and use 
such body-worn accessory should be avoided.
 
FCC Regulations 
This mobile phone complies with part 15 of the FCC Rules. 
Operation is subject to the following two conditions: (1) This 
device may not cause harmful interference, and (2) this device 
must accept any interference received, including interference 
that may cause undesired operation.   
This mobile phone has been tested and found to comply with 
the limits for a Class B digital device, pursuant to Part 15 of 
the FCC Rules. 
These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This 
equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio 
communications. 
 
10 
However, there is no guarantee that interference will not occur 
in a particular installation. If this equipment does cause   
harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of 
the following measures: 
• Reorient or relocate the receiving antenna. 
•  Increase the separation between the equipment and 
receiver. 
•  Connect the equipment into an outlet on a circuit different 
from that to which the receiver is connected. 
•  Consult the dealer or an experienced radio/TV technician for 
help. 
CAUTION: Changes or modifications not expressly approved 
by the party responsible for compliance could void the user’s 
authority to operate the equipment. 
The antenna(s) used for this transmitter must not be 
co-located or operating in conjunction with any other antenna 
or transmitter.