ZTE H108N V.2.1 Configuration manual
Page 13 ZTE Proprietary and Confidential
Connection Type: IPoA (also called static, RFC 2684, formerly 1483)
Encapsulation mode: LLC
WAN IP address: provided by your operator
WAN subnet mask: provided by your operator
Default gateway: provided by your operator
Preferred DNS server: by your operator (Movistar is 80.58.61.250)
Alternate DNS server: by your operator (Movistar is 80.58.61.254)
NAT enabled.
Then refer to the Advanced section (same config as last chapter):
Advanced -> QoS Configuration: these rules are already configured from
factory named as UP_Q_3 and traffic priority is given in the order of this list:
Traffic to the ACS: 80.58.63.192/255.255.255.192.
Traffic for public NGN: 81.47.224.0/255.255.252.0.
Advanced -> Routing -> RIP: rules for 8/32 are turned off.
Finally refer to the Management -> Access Controls -> Services, find the WAN
connection 8/32, and configure the following protection in the table (same config
as last chapter):
Allow ICMP traffic from WAN for all IP address (zero).
Allow FTP, TELNET, HTTP (23, 21, 8000) traffic from WAN for these IP:
IP add = 193.152.37.192,80.58.63.128
Masks = 255.255.255.240,255.255.255.128
Deny all other WAN traffic
2.2.3 Configuration for standalone device with dynamic IP
With standalone setup only one PC can be directly connected to the Internet, as it
does not use NAT. It is strongly recommended to use some kind of protection on
the computer: firewall and antivirus.
In this scenario, the router will transparently work in bridge mode, so your PC will
need to establish manually the PPPoE connection with your Internet Provider
(ISP). In management GUI, it can be set on Setup->Internet Setup:
To Next Page
Loading...
