Zte H108N - Page 30

ZTE H108N V.2.1 Configuration manual
Page 29 ZTE Proprietary and Confidential
Field
Description
Router IP Address
Enter the IP address of LAN interface. It is
recommended to use an address from a block that is
reserved for private use (192.168.1.1-
192.168.255.254). The IP address available in the
DHCP IP address pool changes automatically if you
change the IP address of the device.
Subnet Mask
Enter the subnet mask of LAN interface. The range of
subnet mask is from 255.255.0.0-255.255.255.254.
The default mask 255.255.255.0 allow up to 253
computers in the private network.
Domain Name
Enter the domain name if you know. If you leave this
blank, the domain name obtained by DHCP from the
ISP is used. You must enter host name (system
name) on each individual PC. The domain name can
be assigned from the router through the DHCP
server.
Configure the
second IP Address
and Subnet Mask
for LAN
Select it to enable the secondary LAN IP address.
The two LAN IP addresses must be in the different
network.
By default, Enable DHCP Server is selected for all the Ethernet LAN interface of
the device. DHCP service supplies IP settings to workstations configured to
automatically obtain IP settings that are connected to the device through the
Ethernet port. When the device is used for DHCP, it becomes the default gateway
for DHCP client connected to it.
If you change the IP address of the home gateway, it will also change the range
of IP addresses in the pool used for DHCP on the LAN. The IP address pool can
contain up to 253 IP addresses.