WPS
Select Settings > Wi-Fi Settings > WPS. The WPS configuration is shown in
the following figure:
• PIN: Enter the client PIN that is generated by the wireless access client.
• PBC (Push Button Configuration):
1. Select the PBC mode in the client WPS UI.
2. Select PBC mode in the WPS page of the device and then click Apply. (Or
press the WPS key to active your device’s WPS).
3. (Optional) Please press the "next" key on the client WPS UI. After a few
seconds the client can access the Wi-Fi, and the result will be shown in
the client WPS UI.
SETTINGS
31
To Next Page
Loading...
