Chapter 2 Technical Indexes
Confidential and Proprietary Information of ZTE CORPORATION 33
The input sine jitter value of the SDH regenerator can reach the
amplitude as shown in
Figure 17. The jitter transfer function is
under the curve as shown in
Figure 16.
FIGURE 16 − G.783 JITTER TRANSFER FUNCTION CURVE
FIGURE 17 − JITTER TOLERANCE TEMPLATE DEFINED BY G.783
Note: The values of A3, A4, f2, and f3 source are from G.825.
The input index of the jitter transfer test at the STM-N interface
is described in
Table 9, and the G783 jitter transfer tolerance
index is described in
Table 10.
To Next Page
Loading...