ZXA10 S300 (V1.1) Integrated Access Service Dispatching Unit Technical Manual
66 Confidential and Proprietary Information of ZTE CORPORATION
FIGURE 19 − FRONT SLOTS OF SYSTEM
H1
H2
A1 B1
A2 B2
A3 B3
A4 B4
FIGURE 20 − BACK SLOTS OF SYSTEM
G1
G1
B1L
B2L
B3L
B4L
FIGURE 21 − BOARD TYPES THAT CAN BE INSERTED IN THE SLOTS
OL16A/EAT
TAA/TAAE/TAAED
TAA/TAAE/TAAED
OL/Ethernet
&Transparent/ATM/EAT/RPR
OL/Ethernet
&Transparent/ATM/EAT/RPR
OL/Ethernet
&Transparent/ATM/EAT/RPR
OL/E1 Tributary/Ethernet&Transparent/ATM/EAT
OL/E1 Tributary/Ethernet&Transparent/ATM/EAT
OL/E1 Tributary/Ethernet&Transparent/ATM/EAT
OL16A/E1 Tributary /ESD/EAT
Board Configuration Requirement
Meet the requirements below while configuring boards:
TAA、TAAE、TAAED
The Slots H1 and H2 must be configured with the same type
of the transmission convergence boards. In the dual-system,
the TAA or TAAE can be used, but the 2.5 G optical interface
board with a single optical interface is forbidden.
To Next Page
Loading...