ZXDSL 931DII User Manual
9
Note:
If the first connection is not applicable, please adopt the second connection
method. In the second method, install a MicroFilter on the telephone cable
(as illustrated in Figure 3.3-2, do not use a splitter to replace the MicroFilter).
Install the telephone directly before the splitter installation. Or it will lead to
the ZXDSL 931DII and the central office connection failure,
causing
Internet access
failure, or results in slow connection speed. If a telephone
set is needed to be added before the splitter,
, please add a MicroFilter
before the telephone set. Do not connect several telephones before the splitter
and do not connect several telephones with MicroFilter.
If the MicroFilter is not a standard-configuration device, please separately
purchase it from the operator.
Connection Procedure
1 Power OFF the equipment before all other devices are connected.
2 Connect the network cables: connect the RJ-45 Ethernet cable connector
with the Ethernet interface of the ZXDSL 931 CII. Connect other
terminals to the Ethernet adapter of the user computers or ports of other
network devices.
3 Connect the splitter.
The splitter has three interfaces, which are described as follows:
z LINE: It is connected with the user telephone cable (RJ-11 interface).
z MODEM (or VDSL): It is connected with the Line interface of the
ZXDSL 931DII.
z PHONE (or TEL): It is connected to the phone sets.
z The installation process is as follows: Connect the Line interface of the
ZXDSL 931DII to the splitter MODEM interface by using the RJ-11
telephone cable. Connect the phone set lines to the splitter PHONE
To Next Page
Loading...
