2. Configuration Preparation
2.1 Preliminary Set-up
The GibFibreSpeed Network Access team will set-up and configure the F668
remotely.
The F668 has a default Wi-Fi SSID and WAP-PSK, which can be found on a label
attached underneath the unit. The SSID and WPA-PSK can be change for, or by, the
client if required.
2.2 Logging in to the Device
Perform this procedure to log in to the device.
Prerequisites
Ensure all optical fibre and LAN cables are connected properly to the F668 and a
computer or other device is correctly configured.
1. Open a Web Browser and enter http://192.168.1.1 (default IP address of the
device) in to the URL address bar and press Enter.
The login dialog box is displayed, as shown in Figure 2-1.
Enter the Username and Password (by default, both are admin ).
Click Login to open the main window.
Figure 2-1 Login Window
2-6
Page 10
To Next Page
Loading...
