Zte ZXHN H3600 - Configure the Qos Congestion Management

ZXHN H3600 Maintenance Management Guide
Parameter Description
Name To create a QoS classification, enter the name of the classifica-
tion.
Classification Priority It can be modified by ISP.
Packets Classification Criterion
All Interface Set radiobox On to enable all Interface.
Ingress Specify the data traffic direction.
Source MAC Address Source host MAC address.
Destination MAC Address Destination host MAC address.
802.1p Specify the 802.1p value to modify the service priority.
VLAN ID Identifies a VLAN. Range: 0–4094. To ensure normal service op-
eration, the VLAN ID must be the same as that set in upper-layer
configuration.
Level 2 Protocol The level 2 protocol includes: Unconcerned, IPv4, IPv6, ARP and
PPPoE.
Source IP Source host IP address.
Destination IP Destination host IP address.
DSCP DSCP value.
Level 3 Protocol The Level 3 Protocol includes: Unconcerned, TCP, UDP and
ICMP.
Source Port Source port number of the matching packets.
Destination Port Destination port number of the matching packets.
TCP ACK Set radiobox On to enable the function of TCP ACK.
Packets Classification Result
802.1p Re-marking 802.1p identifier value.
DSCP Re-marking DSCP identifier.
Queue Priority Range:1-8.
3. Click Apply button to apply the changes.
5.3.3 Configure the QoS Congestion Management
The procedure provides the parameters of QoS congestion management configuration
features.
28 SJ-20201203151144-003 | 2021-06-16(R1.0)