5 Configure the Internet
Figure 5-20 Service Control-IPv6 Page
Table 5-14 lists the Service Control-IPv6 parameters.
Table 5-14 Parameter Descriptions for the Service Control-IPv6
Parameter Description
On/Off Click On to enable the function.
Click Off to disable the function.
Name Name of the Service Control item.
The name must be specified.
Target Specify to discard or permit the data packages.
Ingress Specify the data stream inbound direction, and this parameter must
be specified.
If the Ingress is WAN_All, all the WAN connection can access
ZXHN H3600.
If the Ingress is LAN, the LAN side can access ZXHN H3600.
Prefix IPv6 address prefix.
Service Type Type Specify the service that is permitted or denied to access.
2. Click Apply button to apply the changes.
Configure the Remote Service Port Control-IPv4
1. Click Remote Service Port Control - IPv4 to open Remote Service Port Control -
IPv4 page, see Figure 5-21.Remote Service Port Control - IPv4 Page
SJ-20201203151144-003 | 2021-06-16(R1.0) 37
To Next Page
Loading...
