Zte ZXR10 2900 Series - Figure 76 Remote Loop Network

ZXR102900SeriesUserManual
FIGURE76REMOTELOOPNETWORK
CongurationofswitchA:
zte(cfg)#setethernet-oamen
zte(cfg)#setethernet-oamport1en
CongurationofswitchB:
zte(cfg)#setethernet-oamenable
zte(cfg)#setethernet-oamport2enable
zte(cfg)#showEthernet-oamport2discovery
PortId2:ethernetoamenabled
LocalDTE/*thelocaldeviceinformation*/
-----------
Config:
Mode:active/*theportmodemustbeactive,orthediscoveryisfailure*/
Period:10*100(ms)
LinkTimeOut:5(s)
Unidirection:nonsupport
PDUmaxsize:1518
Status:
Parser:forward
Multiplexer:forward
Stable:yes
/*yesrepresentsthatdiscoverysucceeds.norepresentsdiscoveryfails.*/
Discovery:done
/*discoverysucceeds.“undone”representsthatdiscoveryfails*/
Loopback:off
PDURevision:92
RemoteDTE/*theremotedeviceinformation*/
-----------
Config:
Mode:active
LinkMonitor:support
Unidirection:nonsupport
RemoteLoopback:support
MibRetrieval:nonsupport
PDUmaxsize:1518
Status:
Parser:forward
Multiplexer:forward
Stable:yes
MacAddress:00.d0.d0.29.28.02
/*thesystemMACoftheremotedevice.
TheMACaddressis00.00.00.00.00.00whendiscoveryfails.*/
PDURevision:967
zte(cfg)#setethernet-oamremote-loopbackport2start
zte(cfg)#showethernet-oamport2discovery
PortId2:ethernetoamenabled
LocalDTE
-----------
Config:
Mode:active
Period:10*100(ms)
LinkTimeOut:5(s)
Unidirection:nonsupport
PDUmaxsize:1518
Status:
Parser:discard/*theparserstateisdiscard*/
Multiplexer:forward
Stable:yes
Discovery:done
Loopback:on(Master)
/*thelocalistheactiveoriginator(Master).Theotherenddisplaysasslave.*/
190CondentialandProprietaryInformationofZTECORPORATION