Zte ZXR10 2900 Series - Figure 77 Link Control Network; OAM Link Control Event Configuration Example

Chapter7ServiceConguration
PDURevision:1431
RemoteDTE
-----------
Config:
Mode:active
LinkMonitor:support
Unidirection:nonsupport
RemoteLoopback:support
MibRetrieval:nonsupport
PDUmaxsize:1518
Status:
Parser:loopback/*theparserstateisloopback*/
Multiplexer:discard/*themultiplexerstateisdiscard*/
Stable:yes
MacAddress:00.d0.d0.29.28.02
PDURevision:28
zte(cfg)#setethernet-oamremote-loopbackport2stop
/*disableOAMremote-loopbackonport2.
TheswitchrepliesOAMdiscoverysuccess.*/
Thekeypointsofconguration:
TheswitchgivesthefollowingpromptswhenOAMdiscoveryfailure
occurs,orstartingandstoppingremoteloopback.
OAMdiscoveryiscompletedsuccessfullyonport2,thefollowing
informationappears.
SATJUL0323:30:002004ETH-OAMport2'sdiscoveryprocessissuccessful.
Disconnectthenetworkcablebetweenswitches,thefollowingin-
formationappears.
SATJUL0323:33:002004ETH-OAMport2deteced
afaultinthelocalreceivedirection.
OAMLinkControlEventConfigurationExample
OAMmonitorfunctioncannotifytheabnormalframeofthelink
receivertothelocal.ThefunctionisbasedonOAMdiscovery.The
userlogsintotheswitchthroughconsoleportandconguresOAM.
EnableOAMandtheportlinkmonitoroftheotherend.Thenthe
errorframeandtheerrorsymbolcanbedetectedandannounced
tolocalswitch.
FIGURE77LINKCONTROLNETWORK
CongurationofswitchA:
zte(cfg)#setethernet-oamenable
zte(cfg)#setethernet-oamport2enable
CongurationofswitchB:
zte(cfg)#setethernet-oamenable
zte(cfg)#setethernet-oamport1enable
zte(cfg)#setethernet-oamport1link-monitorenable
zte(cfg)#setethernet-oamport1linsymbol-periodthreshold10window10
zte(cfg)#setethernet-oamport1linframethreshold10window20
zte(cfg)#setethernet-oamport1link-monitorframe-periodthreshold
CondentialandProprietaryInformationofZTECORPORATION191