Zte ZXR10 2900 Series - Cluster Management Configuration Example

Chapter8NetworkManagement
CommandFunction
zte(cfg)#showgroupThisdisplays
clusterconguration
information.
zte(cfg)#showgroupcandidateThisdisplayscandidate
switchesinformation.
zte(cfg)#showgroupmember[<1-255>]Thisdisplayscluster
memberswitches
information.
ClusterManagementConfiguration
Example
AsshowningureCLUSTERMANAGEMENTNETWORKING,the
initialcongurationoftheswitchesisthedefaultconguration.
Here,settheVLANwherethepublicnetworkIPaddressof
thecommandswitchintheclusterislocatedto2525,theIP
addressto100.1.1.10/24,thegatewayaddressto100.1.1.1,the
clustermanagementVLANto4000,theprivateaddresspoolto
192.168.1.0/24,andtheIPaddressoftheTFTPServerofthe
wholeclusterto110.1.1.2.
Thedetailedcongurationisasfollows:
1.CongurethepublicnetworkIPaddressofthecommandswitch
andthegateway.
WYXX(cfg)#setvlan2525enable
WYXX(cfg)#setvlan2525addport1-16tag
WYXX(cfg)#configrouter
WYXX(cfg-router)#setipport25ipaddress100.1.1.10/24
WYXX(cfg-router)#setipport25vlan2525
WYXX(cfg-router)#setipport25enable
WYXX(cfg-router)#iproute0.0.0.0/0100.1.1.1
2.Createaclusteronlayer3port1ofthecommandswitchand
VLAN1(defaultVLAN).
WYXX(cfg)#configgroup
WYXX(cfg-group)#setgroupcommanderipport1
ip-pool192.168.1.1/24
Cmdr.WYXX(cfg-group)#ztpstart
Cmdr.WYXX(cfg-group)#showztpdevice
Lastcollectionvlan:1
Lastcollectiontime:188ms
IdMacAddressHopRoleHostNamePlatform
---------------------------------------------------------
000.d0.d0.fc.08.6c0cmdrzteZXR102926
100.d0.d0.fc.08.d61candizteZXR102909
200.d0.d0.fc.08.c31candizteZXR102918
300.d0.d0.fc.08.f52candizteZXR102918
400.d0.d0.fc.08.d52candizteZXR102926
500.d0.d0.fc.09.3a1candizteZXR102818S
Cmdr.WYXX(cfg-group)#setgroupadddevice1-5
Addingdeviceid:1...Successedtoaddmember!
Addingdeviceid:2...Successedtoaddmember!
Addingdeviceid:3...Successedtoaddmember!
Addingdeviceid:4...Successedtoaddmember!
CondentialandProprietaryInformationofZTECORPORATION211