Zte ZXR10 - Installation Method; Fig. 2.3-1 the Process of Installing the W140 A

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge
Professional Installation Instruction Manual
2-12
End
Installing
antenna
Installing
mounting panel
Installing
backplane
Installing
W140A
Connecting
cable
Installing
support
Start
Wall-mounted
mode
Pole-mounted
mode
Roof-mounted
mode
Side wall-
mounted mode
Fig. 2.3-1 The Process of Installing the W140A
2.3.2 Installation Method
The W140A can be installed in four modes: Wall-mounted mode, pole-mounted mode,
roof-mounted mode and side wall-mounted mode. You should choose a proper mode
based on the actual requirement.
2.3.2.1
Wall-Mounted Mode
The wall-mounted mode is suitable for installing an omni antenna or a directional
antenna. Following is an example of how to install the W140A with an omni antenna in
the wall-mounted mode. You may install the W140A with a directional antenna in the
similar way.
Fig. 2.3-2 shows the necessary components in the wall-mounted mode.