Chapter Error! Style not defined. Error! Style not defined.
2-15
Fig. 2.3-4 shows the components in the pole-mounted mode.
2
3
4
5
6
1
1. Installing support B 2. Backplane 3. Mounting plane 4. Omni antenna 5. Antenna stand kit 6. W140A
Fig. 2.3-4 The Necessary Components in the Pole-Mounted Mode
To install the W140A in the pole-mounted mode, follow the steps below:
1. Installing the mounting panel: Fix the mounting panel to the concrete pole using
a lock ring.
2. Installing the backplane: There are four fastening holes in the backplane of the
W140A, as shown in Fig. 2.3-3. Fix the backplane to the wall using four
matched screws.
3. Installing the antenna: Fix the antenna stand to the left and right locks in the
W140A using a U-shape fixture. Do not screw it too tight. Then fix the omni
antenna to the antenna stand using a U-shape clamp.
To Next Page
Loading...
