ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge
Professional Installation Instruction Manual
2-18
1
2
3
4
5
1. Lightning arrester 2. Installing support A 3. W140A 4. Omni antenna 5. Backplane and mounting panel
Fig. 2.3-6 The Necessary Components in the Roof-Mounted Mode with an Installing support A
Following are steps of installing an omni antenna in the roof-mounted mode.
1. Installing the antenna stand: Fix the three pole supports to the installing support
using fixing gaskets and screws. Put the installing supports fixed with three
supports on the mounting base (a concrete base or flat roof). Mark the
installation holes in the pole supports, and remove the installing support. Then
drill the holes in the marked places, and secure the installing support to the
To Next Page
Loading...
