Zte ZXR10 - Page 56

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge User’s Manual
5-24
Parameter description:
Name Range Description
A.B.C.D IP address
Addresses of the proxy Trap destination hosts (up
to 10)
10. snmp sysname
Command mode: Configure mode
Function: Set the name of the managed equipment
Command format: wlan (config) #snmp sysname sysName
Parameter description:
Name Range Description
sysName 1~255 characters
A management variable of the system group in
RFC1213 MIB, used as the name of the managed
equipment
11. snmp trap enable
Command mode: Configure mode
Function: Configure if the SNMP Agent is allowed to send Trap
Command format: wlan (config) #[no] snmp trap enable
12. snmp authtrap enable
Command mode: Configure mode
Function: Configure if the SNMP Agent is allowed to send the authentication
failed Trap
Command format: wlan (config) #[no] snmp authtrap enable
13. snmp traphost
Command mode: Configure mode
Function: Add the address of a trap destination host and the trap version number
Command format: wlan (config) #snmp traphost A.B.C.D [version version]
wlan
（
config
）
#no snmp traphost A.B.C.D