Zte ZXR10 - Commands to Configure VLAN

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge User’s Manual
5-26
the flash disk.
Command format: wlan (config) #tftp get A.B.C.D flash-file-name
Parameter description:
Name Range Description
A.B.C.D IP address
IP Address of a TFTP server in dotted decimal
format
flash-file-name Filename of a version
Full name (including the extension name) of the file
to be transmitted from the TFTP server
4. Upload files using tftp put
Command mode: Configure mode
Function: Upload files from the flash disk to the TFTP server using TFTP
Command format: wlan (config) #tftp put A.B.C.D flash-file-name
Parameter description:
Name Range Description
A.B.C.D IP address
IP Address of a TFTP server in dotted decimal
format
flash-file-name Filename of a version
Full name (including the extension name) of the
file to be transmitted from the flash disk
5.4.21 Commands to Configure VLAN
1. vlan ap-vid
Command mode: Configure mode
Function: Configure the VLAN ID of AP
Command format: wlan (config)
#vlan ap-vid
value
Parameter description:
Name Range Description
value 0~4094 VLAN ID
2. vlan enable
Command mode: Configure mode
Function: Enable VLAN